Special tool
Bearing housing 502-009/6 | Bearing kit for 14 mm bolt, 51204 | Rear axle front bush mounting tool 205-825/3 | Rear differential rear hub mounting tool 502-009/2 |
Dismantling/mounting tool: long bolt with a diameter of 14 mm 502-009/5 | Nut for a long bolt with a diameter of 14 mm 502-009/4 | Receiver for front axle front hub 205-825/1 |
Removing
CAUTION: Make sure the bushing is positioned correctly.
NOTE: Note the position of the bushing.
1.
WARNING: It is forbidden to carry out work on a vehicle standing on only one jack. Always support the vehicle with jack stands.
Raise and support the vehicle.
2. Remove the front wheels.
3. Install the front differential. For more information refer to Bridge assembly (54.10.01)
4.
NOTE: Note the position of the bushing.
Using the special tools, remove the front axle housing support pad.
Installation
1.
CAUTION: Make sure the bushing is positioned correctly.
Using the special tools, reinstall the front axle housing support pad.
2. Install the front differential. For more information refer to Bridge assembly (54.10.01)
3. Install the front wheels. Tighten wheel nuts (tightening torque 140 Nm).
Comments on this article