Removal and installation the accelerator pedal (Discovery 3)

Removal

1. Remove the decorative panel from the driver's side.

• Release the clamp.
• Remove two screws.
• Disconnect the electrical connector.

2. Remove the accelerator pedal assembly.

• Release the wiring harness.
• Unscrew the three nuts.
• Disconnect the electrical connector.

3.

NOTE: Do not perform further disassembly if the part is removed only for access.

Remove the accelerator pedal bracket. Unscrew the 3 nuts and bolts.

Installation

1. Attach the accelerator pedal bracket. Tighten the nuts and bolts. (tightening torque 10 Nm).

2.

NOTE: Make sure the electrical connector is securely fastened.

Install the accelerator pedal assembly.

• Connect the electrical connector.
• Tighten the nuts (tightening torque 25 Nm).
• Secure the wiring harness.

3. Install the decorative panel.

• Connect the electrical connector.
• Secure the clamp.
• Tighten the screws.

4. Initialize the new accelerator pedal using T4.