Removing
1. Fasten the hood in the service position. Release the hood pillars.
2. Disconnect the wire "masses" from the battery. For more information refer to Specification.
3. Remove the engine cover. For more information refer to Engine Cover - 4.4L (12.30.50)
4.
WARNING: Plug all open connections to avoid contamination of the system.
Remove the fuel temperature sensor.
- Disconnect the plug connector.
- Lay down an absorbent cloth to soak up spilled liquid.
Installation
1. To install, follow the removal procedure in reverse order.
- Clean the contact surfaces of the parts.
- Apply sealant to the sensor threads.
- Tighten Gauge (tightening torque 7 Nm).
Comments on this article