Crankshaft Position Sensor Pulse Wheel 2.7L (Discovery 3)

Special tool

Device for installing the part - crankshaft position sensor (CPS) ring 303-1130

Removal

NOTE: Each time the CKP sensor ring is removed, it must be discarded and replaced.

1.

CAUTION: Never work on a vehicle supported solely by a jack. Always support the vehicle securely.

Raise and support the vehicle.

2. Manual transmission models: Remove the flywheel. For more information, refer to Flywheel (12.53.07)

3. Automatic transmission models: Remove the flexplate. For more information, refer to Flexplate (12.53.13)

4. Remove the CKP sensor. Unscrew the Allen bolt.



5.

CAUTION: Proceed with caution to avoid damage to the crankshaft.

Remove the CKP sensor ring. Carefully remove the CKP sensor ring.

Installation

1. Install the new CKP sensor ring on the special tool.

• Rotate the special tool until the end of the thread.
• Engage the CKP sensor ring with the mounting pin.

2. Install the CKP sensor ring onto the crankshaft.

• Clean the contact surfaces of the parts.
• Align the pin and install the special tool onto the crankshaft.
• Tighten the 2 Allen bolts.
• Tighten the nut of the special tool for installing the CKP sensor onto the crankshaft.
• Remove the special tool.

3. Install the CKP sensor. Tighten the Allen bolt. (tightening torque 6 Nm).



4. Manual transmission models: Install the flywheel. For more information, refer to Flywheel (12.53.07)

5. Automatic transmission models: Remove the flexplate. For more information, refer to Flexplate (12.53.13)

(The original article can be found here: «LRMAN.RU»)