Hydraulic compensators, engine kit (Freelander 1)

Dismantling

1. Disconnect the negative battery terminal.

2. Remove the camshafts.

ENGINE - Td4, Intake and exhaust camshafts, Intake and exhaust camshafts.

ENGINE - Td4, Intake and exhaust camshafts, Intake and exhaust camshafts.

(Data taken from the website: lrman.ru)

3. Remove the hydraulic lifters and arrange them in the order in which they were installed.

4. Remove the hydraulic compensators. If you intend to use them further, arrange them in the order in which they were installed.

ATTENTION: Hydraulic compensators must be stored in the order in which they were installed and, at the same time, in an inverted position so that oil does not leak out of them. When working with hydraulic compensators, the maximum possible cleanliness must be observed. Failure to comply with these requirements may lead to engine failure.

Installation

1. Wash the hydraulic lifters and their seats in the cylinder head.

2. Lubricate the hydraulic lifters and their seats in the cylinder head with clean engine oil.

3. If the old hydraulic lifters are used, install them in the order they were previously installed.

4. Flush the hydraulic lifters.

5. Lubricate the hydraulic lifters with clean engine oil.

6. Install the hydraulic lifters in their original order.

7. Place the camshafts.