Replacing the front crankshaft oil seal (Freelander 1)

Dismantling

1. Disconnect the negative battery terminal.

2. Remove the crankshaft pulley.

ENGINE - Td4, Inlet and outlet camshafts, Crankshaft pulley.

3. Install the LRT-12-165/2 puller thrust bearing until it stops against the crankshaft.

4. Make sure that the hole of the LRT-12-168/1 fixture is free of burrs.



5. Position the LRT-12-168/1 tool against the front crankshaft oil seal and tighten the bolt to remove the oil seal.

6. Remove the LRT-12-165 heel bearing.

Installation

1. Wipe the surface of the bore for the oil seal in the front cover and the sealing surface of the crankshaft.



2. Install the LRT-12-166 oil seal guide onto the crankshaft.



3. Using the LRT-12-167 tool and pulley mounting bolt, install the oil seal.

4. Remove the bolt and tools LRT-12-167 and LRT-12-166.

5. Install the crankshaft pulley.

ENGINE - Td4, Inlet and outlet camshafts, Crankshaft pulley.

6. Connect the negative battery terminal.