Contents: Dismantling ⇩ Installation ⇩
Dismantling
1. Disconnect the negative battery terminal.
2. Raise the front of the vehicle and support it with safety stands.
CAUTION: Do not work under a vehicle supported only by a jack. Always support the vehicle with safety stands.
3. Disconnect the heated oxygen sensor wiring harness from the mounting brackets.
4. Loosen and disconnect the oxygen sensor connector.
5. Remove the oxygen sensor.
Installation
1. Clean the oxygen sensor and its mounting location.
The material was taken from a website www.lrman.ru
2. Install the oxygen sensor and tighten it to 55 Nm.
3. Connect the oxygen sensor connector and secure it to the bracket.
4. Secure the harness with clamps.
5. Remove the supports and lower the vehicle.
6. Connect the negative battery terminal.
Comments on this article