Removing
Verify that the SWL spring compressor is sized to match or exceed the spring rate given in the Specifications section.
Always follow the manufacturer's instructions for use for the spring compressor.
1. Raise and support the vehicle.
WARNING: It is forbidden to carry out work on a vehicle standing on only one jack. Always place the vehicle on secure stands.
2. Remove the wheel. Refer to procedure: Wheel and tire (204-04 Wheels and tires, Removal and installation).
3. Remove the elastic element and shock absorber assembly. Refer to Procedure: Shock Absorber Spring Assembly (204-01 Front suspension, Removal and installation).
4. Install the spring compressor in the vise.
5. Install the shock absorber assembly with the elastic element in the spring compressor.
6.
WARNING: Use a new nut.
Installation
1. Tightening torque: 80 Nm
Use a new nut. Be sure to align the alignment marks as shown in the illustration.
2. Loosen the compression of the elastic element and shock absorber assembly and remove them from the special tool.
3. Remove the spring compressor from the vise.
4. Install the elastic element and shock absorber assembly. Refer to Procedure: Shock Absorber Spring Assembly (204-01 Front suspension, Removal and installation).
5. Install the wheel. Refer to procedure: Wheel and tire (204-04 Wheels and tires, Removal and installation).
Comments on this article