2. Check the power steering fluid: if there are air bubbles in it, wait for the air to escape and add the recommended fluid to the TOP mark.
3. Remove the tank cap and add fluid to the MAX mark.
CAUTION: The fluid reservoir must always be in the reservoir while the system is being bled.
4. Install the filler cap.
5. Start the engine, let it run for 10 seconds, then shut it off.
6. Check the power steering fluid: if there are air bubbles in it, wait for the air to escape and add the recommended fluid to the TOP mark.
7. Start the engine, turn the steering wheel between the extreme lock positions, turn off the engine.
8. Check the power steering fluid level, top up if necessary.
9. Start the engine, let it run for 2 minutes, turn the steering wheel between the extreme lock positions.
10. Check the power steering fluid level, top up if necessary.
Comments on this article