Removing
1. Secure the SRS system.
2. Remove the instrument panel. Refer to Procedure: Control Panel - 2.2L Duratorq - Td4 (501-12 Instrument panel and console, Removal and installation).
3. Remove the coil spring. Refer to Procedure: Clock Spring (501-20B Secondary restraint system, Removal and installation).
4. Remove the instrument panel. Refer to procedure: Instrument panel (413-01 Instrument panel, Removal and installation).
5.
6. Disconnect the keyless start module electrical connector.
7. Disconnect the temperature sensor in the car.
8. Remove both top trim panels.
9. Remove both speakers of the instrument panel.
10. Remove the video display. Refer to procedure: Video system display (415-01 Infotainment system, Removal and installation).
11. Remove the center speaker.
12. Remove the audio block.
13. Remove the climate control unit.
14.
15.
16. Remove extreme section of finishing of the panel of devices from outside the passenger.
17. Remove the glove box. Refer to Procedure: Glove Compartment (501-12 Instrument panel and console, Removal and installation).
18. Disconnect the wiring harness from the upper section of the instrument panel.
19.
20.
21. With assistance, remove the upper section of the instrument panel.
22. Remove the air ducts of both front footwells.
23. Disconnect the wiring harness from the heater and evaporator housing.
24. Disconnect the core of the additional electric heater.
25.
26. Remove the heater and evaporator housing.
Installation
1. Install the heater and evaporator housing. Tightening torque: 7 Nm
2. Install an additional electric heater.
3. Connect the electric auxiliary heater core.
4. Connect the wiring harness to the heater and evaporator housing.
5. Install the air ducts for both front footwells.
6. With assistance, install the upper section of the instrument panel.
7. Screw in bolts of a basic arm of the module of a pillow of safety of the passenger. Tightening torque: 10 Nm
8. Attach the wiring harness to the top section of the instrument panel.
9. Connect the passenger airbag module electrical connectors.
10. Install the glove box. Refer to Procedure: Glove Compartment (501-12 Instrument panel and console, Removal and installation).
11. Establish extreme section of furnish of the panel of devices from outside the passenger.
12. Attach the wiring harness support bracket.
13. Install the climate control unit.
14. Install the audio block.
15. Install the center speaker.
16. Install the video display. Refer to procedure: Video system display (415-01 Infotainment system, Removal and installation).
17. Install both instrument panel speakers.
18. Install both top trim panels.
19. Connect an electric socket of the gauge of temperature in inside of the car.
20. Connect the electrical connector of the keyless start module.
21. Install the instrument panel. Refer to procedure: Instrument panel (413-01 Instrument panel, Removal and installation).
22. Install the clock spring. Refer to Procedure: Clock Spring (501-20B Secondary restraint system, Removal and installation).
23. Install instrument panel. Refer to procedure: Control Panel - 2.2L Duratorq - Td4 (501-12 Instrument panel and console, Removal and installation).
24. Connect a wire of weight to the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).
25. Return the steering column to its original position.
Comments on this article