2. Remove the cotter pin and loosen the castle nut a few turns.
1 - stabilizer, 2 - rubber bushing, 3 - bushing bracket, 4 - bolt, nut and washer, 5 - nut and washer, 6 - castle nut and cotter pin, 7 - rod with ball joints.
3. Using puller 18G1063A, remove the ball joint from the rod.
4. Unscrew the castle nut completely and remove the ball joint.
5. Installation is carried out in reverse order. Tightening torque of the crown nut: 40 Nm.
[The source of the article is located on the website www.lrman.ru]
Comments on this article