Drive traction control (V8i) (Discovery 1)

1. Turn off the ignition.

2. Measure the gap between the drive rod and the groove of the throttle lever finger: the gap should be 0.2 - 2.0 mm (with the throttle closed).



3. If not, remove the drive rod.

4. Rotate the adjusting unit to set the new length of the rod.

5. Install the rod and recheck the clearance.

6. Open the throttle fully: between rod A and small spring B (see picture) there should be a gap of at least 3 mm. If necessary, bend the rod. Recheck all clearances and smooth movement of the rod.