Floor console top panel (Discovery 3)

Removal

1. Remove the switch for the traction-dynamic characteristics and body level optimization unit.

For more information, refer to Suspension and Handling Optimization Switch (86.65.11)

2. Remove both cup holders.



3. Remove the floor console insert.



4. Remove the parking brake switch.

• Remove the plastic insert.
• Remove the screw.
• Connect the electrical connector.

5. Remove the top floor console trim panel.

• Remove the refrigerator compartment cover.
• Remove the rubber insert.
• Remove the plastic insert.
• Remove the screw.
• Release 8 clamps.

Installation

1. Install the top trim panel of the floor console.

• Tighten the screw.
• Install the rubber insert.
• Install the plastic insert.

2. Install the parking brake switch.

• Connect the electrical connector.
• Screw in the screw.
• Install the plastic insert.

[The original was published on the portal: LRMAN.ru]
3. Install the floor console insert.

4. Insert both cup holders.

5. Set the switch for the traction-dynamic characteristics optimization unit and the body level height.

For more information, refer to Suspension and Handling Optimization Switch (86.65.11)