Special tool
Door glass opening handle 501-114 |
Removing
NOTE: The door glass must be lowered by approximately one third.
1. Carefully remove the outer glass seal.
- Remove 2 screws.
- Remove both ends of the seal from the door frame.
2. Remove glass of a window of a forward door.
- Using the special tool, release the 2 clips and lift the window from the power window.
- Tilt the glass forward and remove it from the door.
3.
NOTE: Do not proceed with further disassembly if the part is being removed only for access.
Remove 2 door glass clips.
- Remove 2 Torx head screws.
- Remove 2 spacers.
- Remove 2 flat washers.
- Note the position in which the parts are installed.
Installation
1. Install 2 door glass clips.
- Install spacers.
- Install 2 flat washers.
- Tighten Torx Head Screws (tightening torque 8 Nm).
3. Install the outer glass seal. Tighten the screws.
Comments on this article