Ignition lock cylinder (Discovery 3)

Removal

NOTE: This procedure involves removing and installing the ignition lock cylinder. The ignition lock cylinder and door lock cylinders must be replaced as a set.

1. For easy access, fully extend the steering column.

2. Remove the upper steering column cover. Release the 4 clips.



3. Remove the lower steering column cover.

• Remove 3 Torx head screws.
• Release the steering column adjustment lever.

4. Remove the passive spring.

• Disconnect the electrical connector.
• Release the 2 clamps.

5. Remove the ignition lock cylinder.

• Turn the ignition switch to position 1.
• Insert a pin with a diameter no greater than 2 mm into the hole in the ignition switch housing, press the plunger and release the ignition switch cylinder.

The article was copied from a resource LRMAN.ru

Installation

1. Install the ignition lock cylinder.

• Turn the ignition switch to position 1.
• Insert the part into the guides and press the plunger.

2. Install the passive spring.

• Engage the clamps.
• Connect the electrical connector.

3. Install the steering column covers.

• Tighten the Torx head screws.
• Engage the clamps.
• Secure the adjusting lever.