Right exhaust manifold (Discovery 3)

Removal

1. Disconnect the ground cable from the battery. For more information, refer to Specification

2. Remove the engine cover. For more information, refer to Engine Cover - 4.0L (12.30.50)

3.

CAUTION: Never work on or under a vehicle that is supported solely by a jack. Always support the vehicle securely.

Raise and support the vehicle.

4. Disconnect the exhaust system from the exhaust manifold. Unscrew and discard the 2 bolts.



5. Lower the vehicle.

6. Disconnect the high voltage (HT) electrical connectors. Move the wires aside to gain access.



Original version of the article on the website LRman.ru

7. Remove the exhaust manifold.

• Unscrew 6 nuts.
• Remove the gasket and discard it.

Installation

1. Install the exhaust manifold.

• Clean the contact surfaces of the parts.
• Install a new gasket.
• Tighten the nuts evenly and gradually. (tightening torque 25 Nm).

2. Connect the high voltage electrical connectors.

3. Raise the car.

4. Install the exhaust system.

• Clean the contact surfaces of the parts.
• Screw in new bolts and tighten them. (tightening torque 40 Nm).

5. Lower the vehicle.

6. Install the engine cover. For more information, refer to Engine Cover - 4.0L (12.30.50)

7. Connect the ground cable to the battery. For more information, refer to Specifications