Rear brake hose (Freelander 1)

Dismantling

1. Raise the rear of the vehicle.

CAUTION: Do not work under a vehicle supported only by a jack. Always support the vehicle with safety stands.

2. Remove the wheel.



3. Loosen the clamps securing the wheel speed sensor to the brake hose.

4. Loosen the couplings securing the brake pipe to the brake hose and remove the couplings.

CAUTION: Always plug the fittings and holes to protect the system from dirt.



5. Remove the 2 clamps securing the hose to the bumper and shock absorber bracket.

(See the source on the website: «www.lrman.ru»)

6. Remove the brake hose.

Installation

1. Remove the plugs and clean the end of the brake pipe.

2. Place the hose on the fixing brackets and secure it with clamps.



3. Connect the brake pipes and tighten the couplings to a torque of 17 Nm.

4. Secure the wheel speed sensor cable to the brake hose.

5. Remove air from the brake system.

BRAKE SYSTEM, ADJUSTMENTS, Bleeding the brake system.

6. Reinstall the wheel(s) and tighten the nuts to 115 Nm.

7. Remove the supports and lower the vehicle.