Front intake camshaft oil seal (Freelander 1)

Dismantling

1. Remove the timing belt.

ENGINE KV6 - MODIFICATION K, Camshafts of the left cylinder head, Timing belt.

2. Remove the camshaft oil seal using the LRT-12-147 puller and the LRT-12-129 bolt.

(The original article can be found here: LRMAN.RU)

3. Remove the seal from the LRT-12-147 mandrel and discard it.

Installation

1. Wash the oil seal seat and camshaft.



2. Check that the protective boot LRT-12-203 for installing oil seals is clean. Install the boot on the camshaft.

3. Install the oil seal and, using the LRT-12-148A mandrel, press it into place.

CAUTION: Seals must be installed dry. Do not use the LRT-12-148 driver to install seals.

4. Remove the protective boot LRT-12-203 from the camshaft nose.



5. Install the timing belt.

ENGINE KV6 - MODIFICATION K, Camshafts of the left cylinder head, Timing belt.

6. Add oil to the engine.

MAINTENANCE, Engine Oil and Oil Filter - KV6.