Intake Air Temperature (IAT) sensor (Freelander 2)

NOTE: The removal procedure description may contain installation steps.

Removal

1. Remove the cover and disconnect the ground cable from the battery. Refer to procedure: Specifications (414-00 Charging System - General Information, Specifications).

2. Remove the engine trim. Refer to procedure: Engine Cover - 2.2L Duratorq - Td4 (501-05 Interior Trim, Removal and Installation).





The source of the article is located on the website: LRMAN.RU

5. Tightening torque: 10 Nm



6.

CAUTION: A new O-ring must be installed.

Installation

1. Installation is carried out in reverse order.

CAUTION: Clean mating surfaces of any foreign material.