GENERAL INFORMATION, Precautions when working with electrical equipment.
Removing
1. Disconnect "negative" battery wire.
2. Removing the oil filter head gasket.
ENGINE TD6, REPAIR WORKS, Engine oil cooling heat exchanger gasket.
3. Disconnect the connector from the oil pressure switch.
4. Disconnect the bridge breather hose from the clamp and move it to the side.
5. Turn away a bolt of fastening of a hose of system of cooling to a head of the oil filter.
6. Install a container to catch spilled liquids.
7. Turn away 3 bolts of fastening of a head of the oil filter to the block of cylinders and remove a head of the filter from the block.
8. Remove and discard filter head gasket.
Installation
1. Wipe the mating surfaces on the cylinder block and on the filter head.
2. Install a new gasket on the heat exchanger.
3. Install the oil filter head in place and tighten the mounting bolts. Tightening torque 25 Nm.
4. Screw in the bolts securing the water hose to the filter head and tighten them. Tightening torque 10 Nm.
5. Clamp the axle breather hose.
6. Connect the connector to the contact oil pressure switch.
7. Install the oil cooler gasket.
ENGINE TD6, REPAIR WORKS, Engine oil cooling heat exchanger gasket.
8. Attach "negative" wire to the battery.
Comments on this article