Dismantling
1. Disconnect "negative" battery terminal.
2. Removing the oil filter head gasket.
ENGINE - Td4, Intake and exhaust camshafts, Engine oil cooler gasket.
3. Disconnect the connector from the oil pressure switch.
4. Turn away a bolt of fastening of an arm of a fuel tube to a head of the oil filter.
5. Turn away a bolt of fastening of a casing of an oil dipstick to a head of the oil filter.
6. Install a container to catch spilled liquids.
7. Turn away 3 bolts of fastening of a head of the oil filter to the block of cylinders and remove a head of the filter from the block.
8. Remove and discard filter head gasket.
Installation
1. Wipe the mating surfaces on the cylinder block and on the filter head.
2. Install a new gasket on the filter head.
3. Install the oil filter head in place and tighten the mounting bolts. Tightening torque 25 Nm.
4. Screw in and tighten the bolts of the oil dipstick housing to 10 Nm.
5. Screw in and tighten the fuel pipe bracket bolts to 10 Nm.
6. Connect the connector to the contact oil pressure switch.
7. Install the oil cooler gasket.
ENGINE - Td4, Intake and exhaust camshafts, Engine oil cooler gasket.
8. Attach "negative" battery terminal.
Comments on this article