Oil pump — removal and installation (Freelander 1)

Dismantling

1. Disconnect the negative battery terminal.

2. Remove the oil pick-up pipe.

ENGINE - Td4, Inlet and outlet camshafts, Oil pick-up pipe with mesh filter.

3. Unscrew the 4 bolts securing the oil pump to the cylinder block.

4. Remove the oil pump from the mounting pins, remove the oil pump drive chain from the drive sprocket and take out the oil pump.



5. Secure the oil pump drive sprocket in a vice with soft jaws and unscrew the bolt securing the sprocket to the pump. Remove the sprocket from the pump.

Installation

1. Wipe the drive sprocket and the mating surface on the oil pump shaft.

2. Install the drive sprocket onto the oil pump and screw in its mounting bolt.



The article was copied from this resource (www.lrman.ru)

3. Secure the drive sprocket in a vice with soft jaws and tighten its mounting bolt. Tightening torque 25 Nm. Remove the pump with the sprocket from the vice.

4. Place the chain on the sprocket and install the oil pump on the pins. Tighten the bolts. Tightening torque 25 Nm.

5. Install the oil pickup pipe.

ENGINE - Td4, Inlet and outlet camshafts, Oil pick-up pipe with mesh filter.

6. Connect the negative battery terminal.