Master brake cylinder (Discovery 3)

Removal

1. Remove the brake fluid reservoir. For more information, refer to Brake Fluid Reservoir (70.25.31)

2.

CAUTION: Before disconnecting or disassembling parts, make sure the area around the contact surfaces is clean and dry. To avoid contamination of the system, plug all open connections.

Disconnect the brake lines from the master cylinder.

3. Remove the brake master cylinder.

• Unscrew 2 nuts.
• Remove the sealing ring and discard it.

Installation

1. Install the master cylinder.

Install a new O-ring.

Tighten the nuts (tightening torque 26 Nm).

2. Connect the brake lines. Tighten the brake line fittings. (tightening torque 18 Nm).

3. Install the brake fluid reservoir. For more information, refer to Brake Fluid Reservoir (70.25.31)