Special tool
Dismantling/mounting tool: long bolt with a diameter of 14 mm 502-009/5 | Bearing kit for 14 mm and 16 mm bolt, 51203 | Receiver for rear differential rear hub 502-009/1 |
Rear differential rear hub remover 502-009/2 | Rear differential rear hub mounting tool 502-009/3 |
Removing
NOTE: Note the position of the bushing.
1.
WARNING: It is forbidden to carry out work on a vehicle standing on only one jack. Always support the vehicle with jack stands.
Raise and support the vehicle.
2. Remove wheels.
3. Remove the rear differential. For more information refer to Bridge assembly (51.15.01)
4.
NOTE: Note the position of the bushing.
Using the special tools, remove the rear axle housing support pad.
Installation
1. Using the special tools, install the rear axle housing support pad.
2. Install the rear differential. For more information refer to Bridge assembly (51.15.01)
3. Install wheels. Tighten wheel nuts (tightening torque 140 Nm).
Comments on this article