Oil temperature sensor (Freelander 1)

Dismantling

1. Disconnect the negative battery terminal.

2. Raise the front of the vehicle.

CAUTION: Do not work under a vehicle supported only by a jack. Always support the vehicle with safety stands.

3. Turn the steering wheel all the way to the right.



4. Unscrew the 3 bolts securing the right mudguard panel and remove the panel.

5. Place a container to collect the leaking oil.



6. Disconnect the connector from the sensor.

7. Unscrew the oil temperature sensor.

Installation

1. Clean the threaded part of the oil temperature sensor and the mating surface under the sensor.

2. Apply STC 50552 sealant to the threaded portion of the sensor.

3. Screw in the oil pressure sensor and tighten it. Tightening torque 17 Nm.



4. Connect the connector to the sensor.

5. Install the mudguard panel and secure it with bolts.

6. Set the steering wheel to a position corresponding to the straight-ahead movement of the vehicle.

7. Remove the supports and lower the vehicle.

8. Connect the negative battery terminal.

9. Check the engine oil level and top up if necessary.

MAINTENANCE, Engine oil and oil filter - K1.8.