Contents: Dismantling ⇩ Installation ⇩
Dismantling
1. Disconnect the negative battery terminal.
2. Remove the lower engine guard.
EXTERIOR PARTS, REPAIR WORK, Lower engine protection shield.
3. Disconnect the reversing light switch connector.
4. Unscrew the reversing light switch and discard the sealing washer.
Installation
1. Clean the reverse light switch and the mating surface of the transmission.
2. Install a new sealing washer onto the reversing light switch, screw in the switch and tighten it to 24 Nm.
3. Connect the reversing light switch connector.
4. Reinstall the lower engine guard.
EXTERIOR PARTS, REPAIR WORK, Lower engine protection shield.
5. Connect the negative battery terminal.
Comments on this article