Contents: Dismantling ⇩ Installation ⇩
Dismantling
1. Disconnect the negative battery terminal.
2. Remove the lower engine guard.
EXTERIOR PARTS, REPAIR WORK, Lower engine protection shield.
3. Place a container to collect the oil.
4. Loosen the nuts securing the cover of the first gear contact sensor to the gearbox and remove the cover.
5. Disconnect the connector from the first gear engagement contact sensor.
6. Remove the sensor.
Installation
1. Wipe the mating surfaces of the first gear contact sensor, screw in the sensor and tighten it to a torque of 24 Nm.
2. Remove the container from under the gearbox.
3. Connect the connector to the first gear engagement contact sensor.
4. Check the transmission oil level in the gearbox and top up if necessary.
MAINTENANCE, Manual transmission - PG1.
5. Reinstall the lower engine guard.
EXTERIOR PARTS, REPAIR WORK, Lower engine protection shield.
6. Connect the negative battery terminal.
(The original article can be found here: lrman.ru)
Comments on this article