Driver's lower airbag module (Freelander 2)

NOTE: The removal procedure descriptions in this manual may contain installation steps.

Removal

1. Secure the SRS system. Refer to the procedure: Standard Workshop Procedure (100-00 General Information, Description and Operation).

2. Disconnect the steering column arm and lift the steering column to gain access.

2. Disconnect the steering column arm and lift the steering column to gain access.

3. Tightening torque: 6 Nm

NOTE: If replacement of SRS components is required, the bar code of the new component must be recorded.

NOTE: If replacement of SRS components is required, the bar code of the new component must be…

NOTE: Do not perform further disassembly if the component is removed only for access.

NOTE: Do not perform further disassembly if the component is removed only for access.

[The article is based on information from the website: lrman.ru]

Installation

1. To install, perform the removal procedure in reverse order.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Roman Mitrofanov

Tightening torque specifications
Description and principle of operation
Control scheme
Operating principles
Passenger classification system
Passenger presence detection system
Driver Positioning System
Management and processing

Current article

Driver's lower airbag module

Passenger airbag module
Side airbag module
Upper side airbag module
Passenger Airbag Disable Switch
Removal and installation the clock spring
Driver Classification System Sensor
Side Impact Sensor Column
Front impact sensor

Comments on this article

No comments yet

Freelander 2

Freelander 1