Throttle position sensor (Discovery 1)

1. Disconnect the sensor connector.

2. Unscrew the two mounting screws and remove the sensor.

3. Installation is carried out in reverse order. Pay attention to the correct engagement of the sensor and throttle shafts. The sensor connector should be facing downwards.

[The material was taken from a website: LRMAN.ru]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Konstantin Nazarov

Mpi Fuel Management System (MEMS) — Description
System operation
Adjusting the accelerator cable
Repair — knock sensor
Ignition coils
Coolant temperature sensor
Crankshaft position sensor
Fuel temperature sensor

Current article

Throttle position sensor

Air temperature sensor
Fuel vapor canister valve
Fuel manifold and injectors
Throttle body
Fuel pressure regulator
Oxygen sensor
Air filter

Comments on this article

No comments yet

Discovery 3

Discovery 1