B-Pillar Side Impact Sensor (Discovery 3)

Removal

1.

CAUTION: Before performing any work on the SRS system, read the relevant information carefully.

CAUTION: Always disconnect the battery before working on the SRS system. Disconnect the ground cable first. Never connect the battery with the polarity reversed.

NOTE: If replacement of SRS components is required, the bar code of the new part must be recorded.

1. Set the SRS system to safe mode.

For more information, refer to the Standard Techniques used at the service station.

2. Remove the door sill trim panel.

For more information, refer to Door Sill Trim Panel (76.49.54)

(The text of the article was taken from the website: www.LRman.ru)

3. Remove the side impact sensor.

• Remove 2 Torx head bolts.
• Disconnect the electrical connector.

Installation

1. Install the side impact sensor.

• Connect the electrical connector.
• Tighten the Torx head bolts (tightening torque 8 Nm).

2. Install the door sill trim panel.

For more information, refer to Door Sill Trim Panel (76.49.54)