Navigation system amplifier (Discovery 3)

Removal

NOTE: The navigation system traffic information antenna amplifier is located on the left side of the liftgate. The best station tuning amplifier is located on the right side of the liftgate. The procedure is the same for both components.

1. Remove the upper tailgate trim panel. Release the 4 clips.

2. Remove the navigation system traffic information antenna.

Disconnect the 2 antenna cables.
Disconnect the electrical connector.
Remove the Torx head bolt.
Release the clamp.

Installation

1. Install the navigation system's traffic message receiving antenna.

The article was taken from this resource LRman.ru

Secure the clamp.
Tighten the Torx head bolt (tightening torque 10 Nm).
Connect the electrical connector.
Connect the antenna cables.

2. Install the upper tailgate trim panel. Secure the clips.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Saveliy Ushakov

The device and technical description of the anti-theft system
Anti-theft system antenna
Anti-theft alarm sound signal with battery
Hood switch
The device and technical description of the navigation system
Diagnostics and testing of the navigation system
Pinpoint tests of the navigation system
Navigation system antenna

Current article

Navigation system amplifier

Cellular Phone System (prior to 2009 model year)
Telephone System Operation (Pre-2009 Model Year)
Voice command recognition (up to 2009 model year)
Bluetooth (before 2009 model year)
Telephone system control diagram (before 2009)
Cellular Phone System (2009 model year onwards)
Bluetooth (since 2009 model year)
Telephone System Operation (2009 Model Year Onwards)

Comments on this article

No comments yet

Discovery 3

Discovery 1