Right exhaust manifold (Discovery 3)

Removal

1. Disconnect the ground cable from the battery. For more information, refer to Specification.

2. Remove the exhaust system. For more information, refer to Exhaust System (10/30/08)

3. Remove the fender splash guard. For more information, refer to Fender Splash Guard (76.10.48)

4.

NOTE: The heat shield consists of three parts.

To gain access, remove the upper control arm and brake line heat shields.

• Unscrew 3 nuts.
• Remove 3 bolts.

5. Remove the exhaust manifold.

• Remove 8 bolts.
• Assemble the spacers and discard the bolts.
• Remove the gasket/heat shield mounting bolt.
• Discard the gasket/heat shield.

Installation

1. Clean the contact surfaces of the parts.



2. Install the exhaust manifold.

• Install the gasket/heat shield.
• Tighten the heat shield bolt (tightening torque 25 Nm).
• Tighten the bolts evenly and gradually in the sequence shown to a torque of 20 Nm.

3.

NOTE:The heat shield consists of three parts.

Install the upper control arm and brake line heat shields.

• Screw in the bolts.
• Tighten the nuts.

4. Install the fender splash guard. For more information, refer to Fender Splash Guard (76.10.48)

5. Install the exhaust system. For more information, refer to Exhaust System (10/30/08)

6. Connect the ground cable to the battery. For more information, refer to Specification.