Drain
1. Raise the car on a lift.
2. Remove the lower engine protection shield.
EXTERIOR PARTS, REPAIR WORKS, Engine lower shield.
3. Place a container under the sump drain plug, remove the drain plug and discard the sealing washer. Let the oil drain.
CAUTION: Be careful when draining the oil, it can be very hot.
CAUTION: Avoid prolonged hand skin contact with used engine oil. Used engine oil contains harmful substances that can cause skin cancer or other serious skin conditions.
4. Lower the car.
5. Unscrew the filter cap and discard the 3 filter seals.
CAUTION: Be careful not to allow oil or fluids to come into contact with the generator.
Filling
1. Change the engine oil filter.
ENGINE - Td4, Intake and exhaust camshafts, Oil filter.
2. Install new seals and lubricate them with clean engine oil.
3. Install the oil filter cover and tighten to 25 Nm.
4. Raise the car.
5. Clean the drain plug, install a new O-ring and tighten the plug to 28 Nm.
6. Replace the oil filler cap.
7. Replace the lower motor shield.
EXTERIOR PARTS, REPAIR WORKS, Engine lower shield.
8. Lower the car.
9. Unscrew the oil filler cap and fill in engine oil to the correct level.
FILLING CAPACITIES, LIQUIDS AND OILS, Lubrication system.
10. Start the engine. Let the engine idle until the oil pressure warning light goes off.
11. Stop the engine. Check the oil level again.
12. Check for signs of oil leaks.
Comments on this article