Oil pressure contact sensor (Freelander 1)

Dismantling

1. Disconnect the negative battery terminal.

2. Raise the front of the vehicle.

CAUTION: Do not work under a vehicle supported only by a jack. Always support the vehicle with safety stands.

3. Turn the steering wheel all the way to the right.



4. Unscrew the 3 bolts securing the right mudguard panel and remove the panel.



5. Disconnect the connector from the oil pressure sensor.

6. Place a container under the sensor to collect the oil.

7. Unscrew the oil pressure sensor contact.

Installation

1. Wash the threaded part of the sensor and the mating surface under the sensor.

2. Apply STC 50552 sealant to the threaded portion of the sensor.

3. Screw in the oil pressure sensor and tighten it to a torque of 17 Nm.



4. Connect the connector to the oil pressure sensor.

5. Install the mudguard panel and secure it with bolts.

6. Set the steering wheel to a position corresponding to the straight-ahead movement of the vehicle.

7. Connect the negative battery terminal.

8. Check the engine oil level and top up if necessary.

MAINTENANCE, Engine oil and oil filter - K1.8.