Dismantling
1. Disconnect "negative" battery terminal.
2. Remove a noise-insulating casing of the engine.
KV6 ENGINE - MODIFICATION K, Camshafts of the left cylinder head, Noise-insulating casing of the engine.
3. Loosen and disconnect the oxygen sensor connector.
4. Disconnect the heated oxygen sensor harness from the mounting brackets.
5. Remove the oxygen sensor.
Installation
1. Clean the oxygen sensor and its seat.
2. Install the oxygen sensor and tighten it to 55 Nm.
3. Connect the oxygen sensor connector and secure it to the bracket.
4. Secure the harness in the clamps.
5. Replace the engine soundproof cover.
KV6 ENGINE - MODIFICATION K, Camshafts of the left cylinder head, Noise-insulating casing of the engine.
6. Attach "negative" battery terminal.
Comments on this article