Electric motor for the drive of the flaps of the variable intake system (Freelander 1)

The procedure described also applies to the high power mode throttle actuator motor.

Dismantling

1. Disconnect the negative battery terminal.

2. Remove the engine soundproofing cover.

ENGINE KV6 - MODIFICATION K, Camshafts of the left cylinder head, Soundproofing engine casing.

• a Electric motor for driving the intake system balancing flaps.
• b High power mode damper drive motor.

3. Disconnect the connector from the high power throttle actuator motor.

4. Unscrew the 4 screws securing the electric motor to the intake manifold.

5. Carefully remove the electric motor from the intake manifold.

Installation

1. Wipe the mating surfaces of the electric motor and intake manifold.

2. Check that the gasket already installed on the new electric motor is in the correct position.

3. Install the electric motor, making sure that the damper drive rod is in place.

4. Screw in the screws securing the electric motor to the intake manifold and tighten them to a torque of 1.7 Nm.

5. Connect the connector to the high power throttle actuator motor.

6. Reinstall the engine soundproofing cover.

ENGINE KV6 - MODIFICATION K, Camshafts of the left cylinder head, Soundproofing engine casing.

[The full version is available on the website lrman.ru]

7. Connect the negative battery terminal.