Flywheel — removal and installation (Freelander 1)

Dismantling

1. Remove the clutch assembly.

CLUTCH, REPAIR WORK, Clutch assembly/driven disc and clutch release bearing (release bearing) - K1.8.

2. Loosen, but do not remove, the 6 flywheel mounting bolts.

3. Remove the LRT-12-190 mandrel.

4. Remove and discard the 6 flywheel to crankshaft mounting bolts.

5. With the help of a partner, remove the flywheel.

Installation

1. Wipe the mating surfaces of the flywheel and crankshaft.

2. Make two cuts in the body of the old bolt at an angle of 45° to the threads and use this bolt to remove the remains of the thread locker from the threaded sockets.

[The publication was copied from a web resource www.lrman.ru]

3. With the help of a partner, place the flywheel on the crankshaft, screw it in and lightly tighten the flywheel with new bolts.



4. Install the LRT-12-190 flywheel stopper onto the engine and secure it with 2 bolts.



5. Working crosswise, tighten the flywheel mounting bolts to 80 Nm.

6. Install the clutch assembly.

CLUTCH, REPAIR WORK, Clutch assembly/driven disc and clutch release bearing (release bearing) - K1.8.