Front rear wheel arch extension (Freelander 2)

NOTE: The front rear wheel arch extension must be separated from the rear wheel arch outer service panel.

Removal

1. When replacing the front rear wheel arch extension, the following elements are removed:

Rear bumper trim
Rear side panel
Back door
Side glass in the rear of the body
Inner rear side panel

2. For additional information on this repair procedure, refer to the following sources: For additional information, refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation) / Standard Service Station Techniques (100-00 General Information, Description and Operation).

3. Remove the rear quarter inner panel. For more information, refer to: Rear Quarter Inner Panel (501-30 Rear Sheet Metal Repairs, Removal and Installation).

4. Mill out the contact welding areas.

5. Separate the connections and remove the old panel.

Installation

1. Remove the front rear wheel arch extension from the outer wheel arch service panel.

2. Prepare the mating surfaces of the old and new panels.

3. Drill holes in the new panel in preparation for MIG welding.

4. Position the new panel in the desired location and secure it in place. Check the alignment. If it is correct, proceed to the next step. If not, make the necessary adjustments and recheck before continuing.

5. Perform spot welding.