Removing
1.
NOTE: Loosen clamps individually. Clamps may fall out if not handled carefully.
Remove the front fog light bezel. Release 6 clips.
2. Release the front fog lamp. Remove 3 screws.
3. Remove the front fog lamp. Disconnect the front fog lamp electrical connector.
Installation
1. Dock the front fog lamp electrical connector.
2. Install the front fog lamp. Tighten the screws.
3. Establish a frame of a forward antifog lamp. Fasten the clamps.
4. Check up correctness of adjustment of a light beam of a forward fog lamp.
Comments on this article