Dismantling
1. Remove the seat base trim.
SEATS, REPAIR WORKS, Linings of the basis of front seats.
2. Remove the Torx bolt from the lower rear seat belt attachment point to the body and move the belt to the side.
3. Release the decorative panel from 6 clips and remove it.
NOTE: If disassembly was carried out only to provide access to other elements of the system, then further disassembly operations should not be performed.
4. Remove the 6 fasteners from the decorative panel.
5. Remove from the decorative panel a blind of an intermediate loop of a seat belt.
Installation
1. Install the intermediate seat belt loop cover to the trim panel.
2. Install the fasteners on the decorative panel.
3. Install the decorative panel and secure it with the clips.
4. Install the lower seat belt anchors, tighten the Torx screw and tighten to 40 Nm.
5. Install the seat base trim.
SEATS, REPAIR WORKS, Linings of the basis of front seats.
Comments on this article