Intake Air Temperature (IAT) Sensor (Freelander 1)

North American market countries.

Dismantling

1. Disconnect the connector from the intake air temperature sensor.

2. Loosen the sensor mount and remove it. Discard the gasket.

Installation

1. Wipe the intake air temperature sensor and mating surfaces.

2. Install a new seal on the sensor.

3. Install the temperature sensor and connect the connector.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Konstantin Nazarov

Spark plugs: up to May 2003
Spark plugs: since May 2003
Ignition coil left cylinder head: up to May 2003
Ignition coil left cylinder head: after May 2003
Ignition coil right cylinder head: up to May 2003
Ignition coil right cylinder head: after May 2003
Engine Control Module (ECM)
Engine Control Module (ECM). North American Market

Current article

Intake Air Temperature (IAT) Sensor

Coolant Temperature (ECT) Sensor
Crankshaft Position Sensor (CKP)
Throttle position sensor
Thermostat operation sensor, KV6 engine
Camshaft Position (CMP) Sensor
Knock Sensor (KS)
Contact sensor of the gas pedal position
Combined Manifold Pressure (MAP/IAT) Sensor

Comments on this article

No comments yet

Freelander 2

Freelander 1