Dismantling
1. Disconnect "negative" battery terminal.
2. Remove a noise-insulating casing of the engine.
KV6 ENGINE - MODIFICATION K, Camshafts of the left cylinder head, Noise-insulating casing of the engine.
3. Disconnect the crankshaft position sensor connector from the engine harness.
4. Remove the lower engine protection.
EXTERIOR PARTS, REPAIR WORKS, Engine lower shield.
5. Turn away a bolt of fastening of the gauge of position of a cranked shaft to a transmission and remove the gauge.
Installation
1. Wipe the crankshaft position sensor (CKP) and mating surfaces.
2. Install the crankshaft position sensor, screw in the mounting bolt and tighten it to 9 Nm.
3. Replace the lower motor guard.
EXTERIOR PARTS, REPAIR WORKS, Engine lower shield.
4. Connect the crankshaft position sensor connector to the engine harness.
5. Replace the engine soundproof cover.
KV6 ENGINE - MODIFICATION K, Camshafts of the left cylinder head, Noise-insulating casing of the engine.
6. Attach "negative" battery terminal.
Comments on this article