Contents: Removal ⇩ Installation ⇩
Removal
1. Disconnect the battery.
2. Disconnect the high-voltage wires from the coils and mark the connection points.
3. Place the wires aside.
4. Disconnect the coil connector.
5. Unscrew the 4 nuts securing the coil bracket.
6. Remove the bracket from the intake manifold studs.
7. Move the bracket and coil behind the resonance chamber to remove them from the engine.
8. Remove the wire cover. Mark the connection locations.
9. Unscrew the two wire fastening nuts.
10. Remove the wires from the coil terminals.
11. Unscrew the three screws securing the coil to the bracket and remove the coil.
Installation
12. Installation is carried out in reverse order. The tightening torque of the coil bracket mounting nuts is 8 Nm.
Comments on this article