Wheel bearing and wheel hub (Discovery 3)

Special tool

Rear wheel bearing removal/installation device 204-509/10(LRT-60-033/10)

Rear wheel bearing removal/installation device 205-802/1

Rear wheel bearing removal/installation device 205-802/2

Rear wheel bearing removal/installation device 205-802/3

Rear wheel bearing removal/installation device 205-802/4

Rear wheel bearing removal/installation device 205-802/5

Removal

1.

CAUTION: Never work on a vehicle supported solely by a jack. Always support the vehicle securely.

Raise and support the vehicle.

2. Remove the wheel and tire assembly.

3. Remove the wheel knuckle. For more information, refer to Wheel Knuckle (64.35.10)

4. Remove the adjusting and tension spring.



5. Remove the primary brake shoe.

• Remove the spring clip and pin.
• Rotate the shoe to disengage it from the adjuster plate and return spring.

6. Remove the adjusting plate and spring.

7. Remove the return spring.



8. Remove the secondary brake shoe.

• Remove the spring clip and pin.
• Disconnect the parking brake cable retaining spring from the brake shoe actuator lever.

9. Using special tools, remove the drive flange.



10. Remove the brake disc protective cover. Unscrew 3 screws.



11. Remove the wheel bearing using special tools. Remove the retaining ring.

Installation

1. Clear the elements.

2. Install the wheel bearing using special tools.



3.

CAUTION: Make sure that the bearing seal is not damaged when installing the retaining ring.

Install the retaining ring.



4. Install the brake disc guard. Tighten the bolts. (tightening torque 9 Nm).

5.

CAUTION: Do not use compressed air to clean brake components. Dust from friction materials is harmful if inhaled.

Clean the backing plate and apply grease to the surfaces that contact the brake pads.

6. Clean the regulator and set it to minimum length.

7. Install the secondary brake shoe.

• Attach the parking brake cable retaining spring to the brake shoe actuator lever, making sure the spring is not twisted.
• Install the spring clip and pin.

8. Install the primary brake shoe.

• Install the adjusting plate and spring.
• Install the return spring.
• Install the spring clip and pin.

9. Install the return spring.

10. Install the brake shoe adjuster.

11. Using special tools, install the drive flange.



12. Install the wheel knuckle. For more information, refer to Wheel Knuckle (64.35.10)