Engine Oil Pressure (EOP) Sensor 4.0L (Discovery 3)

Removal

1. Raise and support the vehicle.

2.

CAUTION: Before disconnecting or disassembling parts, make sure the area around the contact surfaces is clean and dry. To avoid contamination of the system, plug all open connections.

Disconnect the ground cable from the battery. For more information, refer to Specification.

The text of the article was taken from the website [LRman.ru]


3. Remove the panel that covers access to the radiator. Unscrew 4 bolts.



4. Remove the EOP sensor.

• Disconnect the electrical connector.
• Place a container to collect any spilled liquid.

Installation

1. To install, perform the removal procedure in reverse order.

• Clean the mating surfaces of the elements.
• Tighten the oil pressure sensor (tightening torque 13 Nm).

2. Check the engine oil level and top up if necessary.