Removing
1. Raise the car on a lift.
WARNING: Place secure stands under the vehicle.
2. Remove the pinion flange. Refer to procedure: Pinion protrusion (205-02 Rear drive axle / differential, Removal and installation).
3.
4. Discard O-rings as they are no longer needed.
Prepare to collect spilled liquid. Clean the area around the element and remove foreign material from it.
Installation
1. Lubricate the O-rings. Refer to procedure: Specifications (205-02 Rear Drive Axle/Differential, Specifications).
CAUTION: Lubricate o-rings only with prescribed materials.
2. Install new o-rings.
3. Install the oil pump. Tightening torque: 6 Nm
CAUTION: Clean area around element and remove foreign material from area.
4. Connect the plug connector.
5. Install drive flange. Refer to procedure: Pinion protrusion (205-02 Rear drive axle / differential, Removal and installation).
6. Check the level and add fluid to the active coupling. Refer to Procedure: Activated Friction Clutch Filler (205-02 Rear Drive Axle/Differential, General Procedures).
Comments on this article