Steering wheel (Discovery 1)

Attention:

• For owners of vehicles with airbags, we recommend reading the section "Passive Safety System".
• Please also read the warnings section "Steering cardan shaft".

Removal

1. Disconnect the battery.

2. Set the steering wheels to the straight-ahead position.

3. Remove the airbag (if installed).

4. Remove the steering column covers, disconnect the horn wire



5. Disconnect the current collector connector.

6. Loosen, but do not remove, the steering wheel mounting nut.

7. Remove the steering wheel from the conical seat on the shaft, remove the nut and washer.

8. Release the bundle of wires from the clip.

9. Remove the steering wheel.

Installation

10. Make sure that the steered wheels are in the straight-ahead position.

(The original text can be found at: www.LRman.ru)

11. Install the steering wheel, straighten the wiring.

12. Remove the current collector fixing tape.

13. Insert the leads of the current collector and turn signal switches into the projections of the steering wheel hub. Place the wheel tightly onto the shaft cone.

14. Tighten the steering wheel mounting nut to a torque of 50 N·m.

15. Reinstall the removed parts.