NOTE: The description of the removal procedure in this manual may include installation steps.
Removing
1. Raise and support the vehicle.
WARNING: It is forbidden to carry out work on a vehicle supported only by a jack. Be sure to install reliable supports under the car.
2. Remove the lower engine protection. Refer to procedure: Motor protection (501-02 Front body panels, Removal and installation).
3. Tightening torque: 25 Nm
WARNING: Fluid leakage is inevitable; use an absorbent cloth or container to collect liquid.
Clean the area around the element and remove foreign material from it. Discard the seal.
Installation
1. To install, follow the removal procedure in reverse order.
2. Check the engine oil level and top up if necessary.
Comments on this article