GENERAL INFORMATION, Precautions when working with electrical equipment.
Dismantling
1. Lay a rag around the filter housing to protect against spilled oil.
2. Unscrew the filter housing cover and remove the filter element. Separate the filter element and filter housing cover. Discard the filter element and 2 O-rings.
Assembly
1. Wipe the housing cover and filter housing.
2. Install 2 new O-rings with clean engine oil.
3. Insert the filter element into the filter housing cover.
4. Screw on the filter housing cover and tighten it to 25 Nm.
5. Remove the rags.
6. Wipe the housing cover and filter housing.
7. Remove the dipstick.
8. Unscrew the oil filler cap and add oil to the correct level.
9. Wipe the oil filler cap and counter mating surface.
10. Screw on the oil filler cap.
11. Replace the dipstick.
12. Start the engine and let it run until the low oil pressure warning light goes out.
13. Visually check for oil leaks around the oil filler neck.
14. Stop the engine. After waiting a few minutes, check the oil level. Add oil if necessary.
Comments on this article